Toll Free – 1-866-702-5937

×

Our Warranty

THE FRONT DOOR COMPANY

NON-PRORATED WARRANTY

FIBERGLASS /STEEL ENTRANCE DOORS

FOR ORIGINAL OWNERS

The Front Door Company Fiberglass/Steel entrance doors are warranted by The Front Door Company the manufacturer, to the original purchaser against defects in material and workmanship, as specified under the Warranty, occurring as a direct result of the manufacturing process, for the following door parts and conditions contained in the Warranty.

10 YEARS – DOOR

For a period of ten (10) years from the date of installation, The Front Door Company warrants that Fiberglass/Steel doors purchased in the factory paint/stain finish shall have no finish defects causing blistering, peeling, or flaking. Exposure to sunlight, air pollutants and normal atmosphere conditions can cause Fiberglass/Steel surfaces to gradually fad or chalk or suffer discolouration from any accumulation of surface dirt or stains. These are normal occurrences and are not covered under this Warranty. This warranty on the Fiberglass/Steel door and vinyl cladded frame shall remain in effect only if normal cleaning practices are followed. EXCLUSIONS 1) The Front Door Company does not warrant door if storm door is installed in front of door.

5 YEARS – WORKMANSHIP

From a period of five (5) years from the date of installation, The Front Door Company warrants that Fiberglass/Steel doors shall have no defects of fabrication attributable to materials or workmanship and shall serve for the purpose of normally intended.

5 YEARS – INSULATING GLASS

For a period of five (5) years from the date of installation , The Front Door Company warrants that the sealed units contained in the doors, under normal conditions will not develop and obvious obstruction of vision which is the result of film formation or dust collection between the interior of the glass surface caused by seal failure. (and NOT GLASS BREAKAGE)

2 YEARS – HARDWARE

For a period of two (2) years from the date of installation, The Front Door Company warrants that the hardware shall remain in good operational condition.